Based on Raspberry Pi Zero 2 W, the Bee Write Back writerdeck is another DIY project that should be relatively easy to reproduce, since it relies on...

Yesterday, I wrote about a 2-year-old open-source hardware ESP32-based DAB+ receiver project, but it turns out there's also a digital radio project for...

When I wrote about a DIY ESP32-S3 internet radio last week, "raspbeguy" commented he'd rather choose an ESP32-based DIY DAB+ receiver kit, such as the one...

While checking out MicroPython v1.28 changelog, I noticed a board from WeAct Studio based on ST's STM32U5 Cortex-M33 microcontroller: the WeAct...

GL.inet Comet 5G (GL-RM10RC) is a KVM over IP solution with a 3.69-inch touchscreen display and 5G RedCap (Reduced Capability) IoT cellular connectivity,...

wolfSSL wolfIP is open-source, lightweight TCP/IP stack with no dynamic memory allocations designed for resource-constrained embedded systems.

CircuitMess NASA Artemis Watch 2.0 is a programmable, NASA-themed smartwatch based on an ESP32-S3 WiFi and Bluetooth module and a 1.14-inch monochrome...

Advantech MIO-5356 is an industrial-grade, 3.5-inch fanless SBC powered by Wildcat Lake processor up to the Intel Core 7 350 hexa-core SoC...

Aethyr Research has released post-quantum encrypted IoT edge node firmware for ESP32-S3 targets that boots in 2.1 seconds and supports full PQC (Post...

RealTek RTL8159 10GbE to USB 3.2 adapters sell for $55 and up, and perform best on 20 Gbps USB ports, not so much on Thunderbolt/USB4 ports...

Sanctuary Systems' Sentinel Core is a Raspberry Pi CM5 mini-ITX carrier board with a PCIe x16 slot to easily connect a graphics card to accelerate 3D...

Mekotronics is known for its unusual Rockchip devices, and the R57-5S is a Rockchip RK3576 mini PC for kiosks and digital signage applications with a...

Telink has launched the TL322x wireless MCU family, starting with the TL3228, featuring a 192 MHz dual-core RISC-V MCU, and supporting Bluetooth 6.0,...

Waveshare CM5-ETH-RS485-4G-BASE Raspberry Pi CM5 carrier board offers GbE and 2.5GbE RJ45 jacks, 4G LTE/5G cellular, RS485, DIO, relay...

Sipeed T256s is a portable USB thermal camera equipped with a native 256×192 Long-Wave Infrared (LWIR) sensor and a built-in 2.4 TOPS NPU for...

Flash Bee is an easy-to-make DIY handheld lightning detector based on an ESP32-C3 board, a round display, and AMS AS3935 lightning sensor.

ASUS Zenbook A16 is one of the first Copilot+ PCs/laptops based on the Qualcomm Snapdragon X2 Elite Extreme 18-core Armv9 SoC and is now available for...

IBASE Technology MBB1002 eATX (Extended ATX) motherboard is powered by AMD EPYC Embedded 8004 series processors and takes up to 576GB DDR5-4800 ECC memory...

Designed by Granz Scientific LLC, the SN1 Solar Node is an ESP32-C3-based IoT node/development board designed specifically for off-grid IoT projects.

AAEON Intelli TWL01 Edge is an industrial mini PC with dual 4K display support powered by an Alder Lake-N/Twin Lake processor up to the Intel Core 3 N355...

WeAct CH32V006F8U6 Mini Core is an inexpensive, tiny development board based on the 48 MHz CH32V006 RISC-V microcontroller and equipped with a USB-C port,...

Velxio is an open-source, self-hosted simulator for Arduino, ESP32, and Raspberry Pi boards that works directly in your web browser.You can drag-and-drop...

The SupTronics X1208 is a UPS and M.2 NVMe SSD HAT for Raspberry Pi 5 designed to offer fast storage and protect the system against data loss during power...

Intel discreetly introduced the Wildcat Lake Core Series 3 CPUs at CES 2026 with some high-level specifications, but no part numbers or exact CPU, GPU,...

Nuvoton's new NuMicro M3331 is a series of 32-bit Arm Cortex-M33 MCUs clocked at 180 MHz that integrate an ARGB LED controller, a DSP instruction set, a...